sd 8:0:0:0: Attached SCSI removable disk sd 8:0:0:0: Assuming drive cache: write through sd 8:0:0:0: No Caching mode page present sd 8:0:0:0: Attached scsi generic sg4 type 0 scsi 8:0:0:0: Direct-Access SanDisk Cruzer 1.14 PQ: 0 ANSI: 2 If I wait for it to complete the copy is successful.Īny ideas? dmesg output below: usb 2-1.2: new high-speed USB device number 5 using ehci_hcd Interrupting the copy at this point seems to result in corruption at the tail end of the file. The problem I seem to see in the GUI is that the progress bar goes to 90% almost instantly, completes to 100% a little slower and then hangs there for 10 minutes. I have a super talent 32GB USB SSD in the neighboring port and it works at expected speeds. To copy 1.8GB takes me over 10 minutes (it should be < 3 min.) I have two identical SanDisk Cruzer 8GB sticks, and I have the same problem with both. It runs fast and doesn't consume resources, because MFC is not used.When I copy files to the USB device, it takes much longer than in windows (same usb device, same port) it's faster than USB 1.0 speeds (1MB/s) but much slower than USB 2.0 speeds (12MB/s).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |